restrict type qualifier (since C99)

Each individual type in the C type system has several qualified versions of that type, corresponding to one, two, or all three of the const, volatile, and, for pointers to object types, restrict qualifiers. This page describes the effects of the restrict qualifier.

Only a pointer to an object type or a (possibly multi-dimensional) array thereof(since C23) may be restrict-qualified; in particular, the following are erroneous:

int restrict *p
float (* restrict f9)(void)

Restrict semantics apply to lvalue expressions only; for example, a cast to restrict-qualified pointer or a function call returning a restrict-qualified pointer are not lvalues and the qualifier has no effect.

During each execution of a block in which a restricted pointer P is declared (typically each execution of a function body in which P is a function parameter), if some object that is accessible through P (directly or indirectly) is modified, by any means, then all accesses to that object (both reads and writes) in that block must occur through P (directly or indirectly), otherwise the behavior is undefined:

void f(int n, int * restrict p, int * restrict q)
{
    while (n-- > 0)
        *p++ = *q++; // none of the objects modified through *p is the same
                     // as any of the objects read through *q
                     // compiler free to optimize, vectorize, page map, etc.
}
 
void g(void)
{
    extern int d[100];
    f(50, d + 50, d); // OK
    f(50, d + 1, d);  // Undefined behavior: d[1] is accessed through both p and q in f
}

If the object is never modified, it may be aliased and accessed through different restrict-qualified pointers (note that if the objects pointed to by aliased restrict-qualified pointers are, in turn, pointers, this aliasing can inhibit optimization).

Assignment from one restricted pointer to another is undefined behavior, except when assigning from a pointer to an object in some outer block to a pointer in some inner block (including using a restricted pointer argument when calling a function with a restricted pointer parameter) or when returning from a function (and otherwise when the block of the from-pointer ended):

int* restrict p1 = &a;
int* restrict p2 = &b;
p1 = p2; // undefined behavior

Restricted pointers can be assigned to unrestricted pointers freely, the optimization opportunities remain in place as long as the compiler is able to analyze the code:

void f(int n, float * restrict r, float * restrict s)
{
    float *p = r, *q = s; // OK
    while (n-- > 0)
        *p++ = *q++; // almost certainly optimized just like *r++ = *s++
}

If an array type is declared with the restrict type qualifier (through the use of typedef), the array type is not restrict-qualified, but its element type is:	(until C23)
An array type and its element type are always considered to be identically restrict-qualified:	(since C23)

typedef int *array_t[10];
 
restrict array_t a; // the type of a is int *restrict[10]
// Notes: clang and icc reject this on the grounds that array_t is not a pointer type
 
void *unqual_ptr = &a; // OK until C23; error since C23
// Notes: clang applies the rule in C++/C23 even in C89-C17 modes

In a function declaration, the keyword restrict may appear inside the square brackets that are used to declare an array type of a function parameter. It qualifies the pointer type to which the array type is transformed:

void f(int m, int n, float a[restrict m][n], float b[restrict m][n]);
 
void g12(int n, float (*p)[n])
{
   f(10, n, p, p+10); // OK
   f(20, n, p, p+10); // possibly undefined behavior (depending on what f does)
}

float *restrict a, *restrict b;
float c[100];
 
int init(int n)
{
   float * t = malloc(2*n*sizeof(float));
   a = t;      // a refers to 1st half
   b = t + n;  // b refers to 2nd half
}
// compiler can deduce from the restrict qualifiers that
// there is no potential aliasing among the names a, b, and c

Function parameter

The most popular use case for restrict-qualified pointers is the use as function parameters.

In the following example, the compiler may infer that there is no aliasing of modified objects, and so optimize the loop aggressively. Upon entry to f, the restricted pointer a must provide exclusive access to its associated array. In particular, within f neither b nor c may point into the array associated with a, because neither is assigned a pointer value based on a. For b, this is evident from the const-qualifier in its declaration, but for c, an inspection of the body of f is required:

float x[100];
float *c;
 
void f(int n, float * restrict a, float * const b)
{
    int i;
    for ( i=0; i<n; i++ )
       a[i] = b[i] + c[i];
}
 
void g3(void)
{
    float d[100], e[100];
    c = x; f(100,   d,    e); // OK
           f( 50,   d, d+50); // OK
           f( 99, d+1,    d); // undefined behavior
    c = d; f( 99, d+1,    e); // undefined behavior
           f( 99,   e,  d+1); // OK
}

Note that it is permitted for c to point into the array associated with b. Note also that, for these purposes, the "array" associated with a particular pointer means only that portion of an array object which is actually referenced through that pointer.

Note that in the example above, the compiler can infer that a and b do not alias because b's constness guarantees that it cannot become dependent on a in the body of the function. Equivalently, the programmer could write void f(int n, float * a, float const * restrict b), in which case the compiler can reason that objects referenced through b cannot be modified, and so no modified object can be referenced using both b and a. If the programmer were to write void f(int n, float * restrict a, float * b), the compiler would be unable to infer non-aliasing of a and b without examining the body of the function.

In general, it is best to explicitly annotate all non-aliasing pointers in a function's prototype with restrict.

Block scope

A block scope restrict-qualified pointer makes an aliasing assertion that is limited to its block. It allows local assertions that apply only to important blocks, such as tight loops. It also makes it possible to convert a function that takes restrict-qualified pointers into a macro:

float x[100];
float *c;
 
#define f3(N, A, B)                                    \
do                                                     \
{   int n = (N);                                       \
    float * restrict a = (A);                          \
    float * const    b = (B);                          \
    int i;                                             \
    for ( i=0; i<n; i++ )                              \
        a[i] = b[i] + c[i];                            \
} while(0)

Struct members

The scope of the aliasing assertion made by a restrict-qualified pointer that is a member of a struct is the scope of the identifier used to access the struct.

Even if the struct is declared at file scope, when the identifier used to access the struct has block scope, the aliasing assertions in the struct also have block scope; the aliasing assertions are only in effect within a block execution or a function call, depending on how the object of this struct type was created:

struct t      // Restricted pointers assert that
{
   int n;     // members point to disjoint storage.
   float * restrict p;
   float * restrict q;
};
 
void ff(struct t r, struct t s)
{
   struct t u;
   // r,s,u have block scope
   // r.p, r.q, s.p, s.q, u.p, u.q should all point to
   // disjoint storage during each execution of ff.
   // ...
}

Keywords

restrict

Example

code generation example; compile with -S (gcc, clang, etc) or /FA (visual studio)

int foo(int *a, int *b)
{
    *a = 5;
    *b = 6;
    return *a + *b;
}
 
int rfoo(int *restrict a, int *restrict b)
{
    *a = 5;
    *b = 6;
    return *a + *b;
}

Possible output:

; generated code on 64bit Intel platform:
foo:
    movl    $5, (%rdi)    ; store 5 in *a
    movl    $6, (%rsi)    ; store 6 in *b
    movl    (%rdi), %eax  ; read back from *a in case previous store modified it
    addl    $6, %eax      ; add 6 to the value read from *a
    ret
 
rfoo:
    movl      $11, %eax   ; the result is 11, a compile-time constant
    movl      $5, (%rdi)  ; store 5 in *a
    movl      $6, (%rsi)  ; store 6 in *b
    ret

References

C23 standard (ISO/IEC 9899:2024):

6.7.3.1 Formal definition of restrict (p: TBD)

C17 standard (ISO/IEC 9899:2018):

6.7.3.1 Formal definition of restrict (p: 89-90)

C11 standard (ISO/IEC 9899:2011):

6.7.3.1 Formal definition of restrict (p: 123-125)

C99 standard (ISO/IEC 9899:1999):

6.7.3.1 Formal definition of restrict (p: 110-112)

Compiler support
Language
Headers
Type support
Program utilities
Variadic function support
Error handling
Dynamic memory management
Strings library
Algorithms
Numerics
Date and time utilities
Input/output support
Localization support
Concurrency support (C11)
Technical Specifications
Symbol index

Basic concepts
Keywords
Preprocessor
Statements
Expressions
Initialization
Declarations
Functions
Miscellaneous
History of C
Technical Specifications

Pointer
Array
enum
struct
union
Bit-field
Atomic types (C11)
const
constexpr (C23)
volatile
restrict (C99)
Alignment specifiers (C11)
Storage duration and linkage
External and tentative definitions
typedef
Static assertions (C11)
Attributes (C23)

cppreference.com

Namespaces

Variants

Views

Actions

restrict type qualifier (since C99)

Contents

Notes

Usage patterns

File scope